514P Mini Drawbolt - nickel plated steel

Current stock is Nickel Plated. Brass Plated can be special ordered.

Overall height is approx. 1.6" and width 1.187". The #514P has two .118" Dia. mounting holes in both top and bottom sections on .820" centers. Distance between hole centers from top to bottom is approx. .750". The height of the top alone is slightly over .525". Ok to use a #2 or #4 flat head screw with this latch. It is also available on special order with a valence cut out.

$8.00 ea

Take-Apart Hinge - nickel plated steel

Take-apart hinges, also known as pin hinges, are used in applications where, for example, the top of a case must be removeable, yet securely hinged.

The #30R Hinge is approx. 1.0" x 1.2" wide and has four .135" dia. mounting holes for rivets or screws. Hole centers are .850" left to right and .625" top to bottom. This hinge is also available on special order in a left hand version.

$8.00 / pair

Butt Hinge - nickel plated steel

Part N° Length Width Holes Screw

#1743 1" 15/16" .130" Dia #4 PPH, #2 PFH

(Length is across the knuckle, Width is overall width when hinge is flat)

$6.00 / pair

Here is an example of the use of the 514P Mini Drawbolt on a small cherry wood box to hold machinists' parallels.

(click on the picture to see a larger image)

The rear view shows the use of the take-apart hinges.

(click on the picture to see a larger image)

(click on the picture to see a larger image)

Take-Apart Hinge taken apart.

(click on the picture to see a larger image)